Jump to content
IGNORED

Intv2 Arcade Controller pre-order / interest list


Recommended Posts

here is pcb5. Yes I did not wire in the keyboard, but the connectors are present and it works fine

 

Here are the changes:

Xilinx CPLD

JST connectors on PCB for keypad, buttons, and joystick

this PCB runs off single AA battery - still might end up with 9v or 4xAA

added 2.0mm JTAG header

I need to clean up some minor things, but its getting close

I already have PCB6 on order - should be here in a week or two

 

most likely production will be pcb7

post-27883-0-67789700-1376105168_thumb.jpg

Edited by grips03
Link to comment
Share on other sites

I honestly don't really understand the significance of what I'm looking at....that said, it looks awesome. :)

 

Its the 7th revision of the pcb for the controller. It contains the connectors for the keypad, buttons, joystick and logic to covert to common ground (arcade type controls) to format Intv likes.

 

I've left the controller on for the past 5 days and it still works fine.

Link to comment
Share on other sites

I brought the cases to milling shop and after looking at it for a bit we figured I need to make a jig to hold the case for the side cut (battery holder). I should be able to make this over the next week.

 

Single AA battery is still working after 8 days of leaving the controller on.

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...