Binarygeek Posted March 26, 2015 Share Posted March 26, 2015 (edited) Hi all I have a 1050 that after power is turned on, the motor starts and stops about every two seconds. LED on, no stepper head movement. Jumpers set up for EPROM, which I am using. Have tried different drive mech, and swapped out all five socketed chips. Still just starts and stops. Ideas would be greatly appreciated. Thanks all, Rick. Edited March 26, 2015 by Binarygeek Quote Link to comment Share on other sites More sharing options...
+bob1200xl Posted March 26, 2015 Share Posted March 26, 2015 When the drive powers on, it runs some tests, loading regs and reading them back - things like that. If it fails, it just branches to the beginning and tries again.. and again.. and again. Sadly, there is no indication as what is happening, just that it failed the bring-up tests. Be nice if they flashed the power light a certain number of times, but they didn't. This doesn't help you much. You should try to get a commented source code listing and see what it may be doing. Is the head at track 0? maybe try it with the head out in the disk - see if it seeks at all. Bob Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.