Dennis88 Posted November 10, 2015 Share Posted November 10, 2015 Common problem at the vectrex controller: button 4 is not working. 3 things what can cause this problem: dirty contacts rubber pad and circuitboard Worn out rubber pad cracked circuitboard In my situation: the circuitboard cracked in the middle including the circuit. the fix - Gently remove the overlay sticker ( use a hairdryer and take your time ) - Remove the screws - Open the controller and unscrew the circuitboard - Clean contacts of rubber pad and circuit board with some alcohol * now the tricky part! * - Picture 2 is showing the crack and fix ( see the crack in the middle of the circuit circle ) - Heat up a soldering iron and gently wipe some solder on the tip of the iron ( not too much! ) - Heat up the circuit circle a little bit where it cracked and then wipe the solder over the crack. - If done correctly the crack has been fixed, now we are going to fortify this spot - Ad some glue over the crack ( front + back of circuit board but only on the board, not circuit! ) - after drying stick some tape at the back and fold a little over the board. * Also you can place a tiny screw at the side of the board ( there is a small hole ) to give more strength 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.