SCART to SC1224

[walter_J64bit]

Can the SC1224 "US" use RGB SCART singals? I want to use my Sega CDX "NTSC" with my SC1224.

Edited February 26, 2016 by walter_J64bit

[galax]

If your SCART cable carries RGB, and the Sega CDX outputs a 50/60Hz vertical 15kHz horizontal signal (which I think it does), then yes, it should. SCART cables also carry other signals such as composite and component, so it depends on how your cable was built- it may only carry the CDX's composite signal.

[walter_J64bit]

If your SCART cable carries RGB, and the Sega CDX outputs a 50/60Hz vertical 15kHz horizontal signal (which I think it does), then yes, it should. SCART cables also carry other signals such as composite and component, so it depends on how your cable was built- it may only carry the CDX's composite signal.

I was thinking it could now need to do some homework on RGB outputs 50/60Hz vertical 15kHz horizontal signal.

[goaltoss]

Yep it will work. I've used my CDX on a SC1224 then a Amiga 1080, then moved to XRGB2 and finally settled on a SONY PVM. Hell your close enough I even have a PVM you could have it you wanted to pick it up

Edited February 27, 2016 by goaltoss

[walter_J64bit]

Yep it will work. I've used my CDX on a SC1224 then a Amiga 1080, then moved to XRGB2 and finally settled on a SONY PVM. Hell your close enough I even have a PVM you could have it you wanted to pick it up

Thanks but my other half would kill me if I get a other pace of hardware but I would like to get the info on using the CDX on a SC1224 I'm going to mod a SCART cable.

[goaltoss]

I just matched the pin out from online. RGB Composit Synch an Ground. Some p used caps but my monitor worked perfectly fine with out any caps of resistors on the RGB

 

I got the Sega pinouts from here but you can just route it to the correct pinouts for the sc1224

http://www.sega-16.com/forum/showthread.php?16337-Connecting-a-Genesis-to-a-Commodore-Amiga-1080-using-RGB