superwill64 Posted April 4, 2016 Share Posted April 4, 2016 My intellivision controllers are borked. I was wondering what the standard procedure was for replacing them. I checked ebay for replacement controllers with no luck. Is it possible to add a port so I can use atari/coleco controllers? Thanks ! Quote Link to comment Share on other sites More sharing options...
+fdr4prez Posted April 4, 2016 Share Posted April 4, 2016 Go here: https://intellivision-productions-inc.myshopify.com/ and order two new Flashback controllers and the needed adapters for the Intv 1 Quote Link to comment Share on other sites More sharing options...
+BBWW Posted April 5, 2016 Share Posted April 5, 2016 Best route listed above, you could try to find a used Intellivision on Craigslist or Goodwill...sometimes parts on ebay. Quote Link to comment Share on other sites More sharing options...
+intvsteve Posted April 5, 2016 Share Posted April 5, 2016 yeah - it may cost about the same to get an old console vs. brand new controllers, but if controllers are the only concern just get them with adapters. In my direct experience, controller issues are a frequent failure point - possibly as much as half of the time. Quote Link to comment Share on other sites More sharing options...
superwill64 Posted April 5, 2016 Author Share Posted April 5, 2016 Great link ! Thanks everyone ! The shipping is a bit steep, I'll have to wait for my next pay Quote Link to comment Share on other sites More sharing options...
mr_me Posted April 8, 2016 Share Posted April 8, 2016 In my case, a bad controller was only a bad cable. I tested continuity for each wire. I repaired it by replacing the cable using an inexpensive genesis extension cable. And yes, in Canada shipping from Intellivision Productions is US$25. Not sure where you are. Someone should do a bulk buy of controllers and resell them on Ebay within Canada; maybe IP would provide a small discount. Quote Link to comment Share on other sites More sharing options...
mr_me Posted April 9, 2016 Share Posted April 9, 2016 My intellivision controllers are borked. I was wondering what the standard procedure was for replacing them. I checked ebay for replacement controllers with no luck. Is it possible to add a port so I can use atari/coleco controllers? Thanks ! If you have an Intellivision 1, you can add a 9-pin port but it would only be compatible with Intellivision controllers. With some modification I think you can make an Atari or Colecovision controller compatible as a 4-way controller. Anything more would need some electronics. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.