metzger130 Posted July 24, 2016 Share Posted July 24, 2016 My roller controller goes L/R and buttons work but it will not go U/D. Is this fixable or is it just a big controller holder now? Quote Link to comment Share on other sites More sharing options...
7800fan Posted July 25, 2016 Share Posted July 25, 2016 Stick roller or seized bearing? Take it apart and see that the horizontal rod spins freely and that the bearing is still loose enough. Then check inside the IR tower where the encoder wheel fits in for dust or contamination. If those checks out, get a digital camera and look into the IR tower slot using the camera. See if you can see IR light from the diode. Most camera can "see" IR and turn that into visible light. If you see light, the photo transistor may be bad or the associated circuitry may be bad. If you don't see light, maybe a burned out IR LED or resistor for the LED. Quote Link to comment Share on other sites More sharing options...
chart45 Posted July 25, 2016 Share Posted July 25, 2016 My roller controller goes L/R and buttons work but it will not go U/D. Is this fixable or is it just a big controller holder now? just to be sure you plug both cable in port 1 and 2 since cause port one do right left and port 2 up and down if i remember right.... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.