SiberianSpForces Posted May 18, 2017 Share Posted May 18, 2017 I recently found my paddle controllers a few days ago. I noticed on both the red side buttons fell in the controller. Popped them open and seen the 2 tabs behind the red button have snapped off. Wondering if anyone has encountered this issue and what did you do to fix it. Quote Link to comment Share on other sites More sharing options...
bohoki Posted May 18, 2017 Share Posted May 18, 2017 i would use a hot glue gun Quote Link to comment Share on other sites More sharing options...
SiberianSpForces Posted May 18, 2017 Author Share Posted May 18, 2017 I think I'll do that!. Be easier than designing, then printing a part. Quote Link to comment Share on other sites More sharing options...
SiberianSpForces Posted May 25, 2017 Author Share Posted May 25, 2017 Got both pots cleaned up. One of the bottom halves still has that peg that holds the switch. I ended up cutting a tip from a Nerf dart and glued it to the top half. Now I hope I still have the bottom half to the 2nd paddle. Quote Link to comment Share on other sites More sharing options...
Tombstone Posted May 25, 2017 Share Posted May 25, 2017 I can send you a couple shells if you like. I have a ton of them. Quote Link to comment Share on other sites More sharing options...
SiberianSpForces Posted May 25, 2017 Author Share Posted May 25, 2017 Greatly appreciated! I'll PM you. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.