cypher007 Posted June 2, 2017 Share Posted June 2, 2017 (edited) bought a light sixer off ebay, which did have bad clour bleed on the RF anyway wasn't to worried as was going to fit a video mod. so ive recapped it, including the mylar cap, and put a new voltage regulator in. it seem fine other than when I turn it on from cold even using the svideo out, which is a pal longhorn mod, I get black and white output for about the first 30 seconds or so. then its in colour for the rest of the time. I thought initially it was a bad b/w colour switch, as it just happened to go into colour mode at the same time I toggled the switch. but I'm guessing it was just coincidence. Edited June 2, 2017 by cypher007 Quote Link to comment Share on other sites More sharing options...
Thomas Jentzsch Posted June 2, 2017 Share Posted June 2, 2017 I have a similar with my modded 2600. But here the black and white phase lasts a few minutes. Quote Link to comment Share on other sites More sharing options...
RevEng Posted June 2, 2017 Share Posted June 2, 2017 Just a guess, but it sounds like the colorburst crystal (or nearby component) is a bit out of spec, and after a bit of warm-up the frequency shifts to where the TV accepts it as colorburst. The other guess would be one of the caps on the COL line have semi-failed. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.