Problem with my Mcwill mod for Game Gear

[GameGear1909]

First of all, Hello everyone, i'm new in this forum.

 

Recently I've bought a Mc will mod for Game Gear and I have a problem:

When I press 1 and 2 buttons at the same time, the screen change its scale. Normally this only happens when you press 1, 2 and start button too at the same time.

Does anyone know if it's possible to fix it?, becouse is a bit annoying because some games needs to press 1 and 2 bottons at the same time.

Thank you in advance.

[mobiusstriptech]

It sounds like you have bridge or you soldered to the wrong point for Start.

[GameGear1909]

It sounds like you have bridge or you soldered to the wrong point for Start.

Thank you for your answer.

I post some pictures about it, just in case someone could help me.

Thank you in advance again

 

 

 

Edited November 20, 2017 by GameGear1909

[mobiusstriptech]

Button 2 is connected on the wrong side of the cap. Switch the wire on c30 to the other side of that cap and give it a shot.

[GameGear1909]

Button 2 is connected on the wrong side of the cap. Switch the wire on c30 to the other side of that cap and give it a shot.

Yes mate!!! You were right!!

 

I did what you say and it's fixed, so I want to thank you very much for your help.

[mobiusstriptech]

Yeah not a problem. Glad that fixed it. I need to take better pictures of both 1ASIC and 2ASIC models and make a slightly easier to follow guide for people doing the McWills screens. I have seen others run into similar issues before.

[cowdog360]

I like the install you did with the wires rather than using the old LCD connector.. where did you find pinouts/instructions for those?

 

Thanks!