Alright guys. Here's what I've come up with so far. Still have to fine tune, and get the internal support structures done, but I'm getting close.
LED's on this case shine through the side of this case. There is no option for an LED through the lid. As with the 32K case, heatsets are used to attach the base to the lid from the back. Finger grips are integrated into the sides of the case to allow for a firm grip when plugging in or pulling the device off your TI99.
An adjustable "Thumbscrew" foot has been integrated into the lid. I did this because, with the two cards now, the case had to become pretty beefy, and as such, hangs pretty far off the side of the machine. I felt it prudent to incorporate some sort of support to take the pressure off the edge connector. I plan on printing this weekend, and with luck, if my measurements are good, I should have something to show to you very soon.
For the time being, have a look at the renders. I did them in black and silver like I've been printing the 32K cases. I plan on doing the same with this new case, but of course, any color combination will be offered.
sm_2018-05-04_22h06_41.jpg 67.58KB 7 downloads sm_2018-05-04_22h06_57.jpg 76.01KB 7 downloads sm_2018-05-04_22h07_08.jpg 44.03KB 5 downloads sm_2018-05-04_22h07_21.jpg 46.47KB 5 downloads sm_2018-05-04_22h07_40.jpg 74.68KB 5 downloads