Drive Select PCB for Drives with No Drive Select Jumpers

[Shift838]

some time ago I put together a DIY pcb that plugs directly into a 3.5 drive and has a dip switch to be able to select the drive number of 1 to 4.

 

I did this because I was tired of hacking cables.

 

This poll is to gauge the community to see if I should make a production run of these. It's fairly simple. a 34 pin female on one end, 4 position dip switch and a 34 pin male on the other end.

 

 

Edited July 16, 2018 by Shift838

[Omega-TI]

Question three should allow the user to select 0 or NONE, especially if they already answered no to question number one

 

I see it's fixed.

Edited July 16, 2018 by --- Ω ---

[+arcadeshopper]

some time ago I put together a DIY pcb that plugs directly into a 3.5 drive and has a dip switch to be able to select the drive number of 1 to 4.

 

I did this because I was tired of hacking cables.

 

This poll is to gauge the community to see if I should make a production run of these. It's fairly simple. a 34 pin female on one end, 4 position dip switch and a 34 pin male on the other end.

 

 

I'll take 10

 

Sent from my LG-H872 using Tapatalk

[+Ksarul]

I'd snag 4-5 as well. . .

[+FALCOR4]

I'd be interested in 4.

[Shift838]

Here is the Pre-Order for the DriveSelect board.

 

HERE.

Edited August 7, 2018 by Shift838