SnesGuy

The most noticeable difference is the logo in the top left is black/white on a Majesco. I scrolled threw pages of auctions/pictures looking for the black/white logo until I found one. Majesco on top, Original GG on bottom. (Yea, they need dusted apparently)

It's a pain, but you can find them on eBay. I got mine in great condition for $15 +sh. It took me a couple days of searching auction pics for the cosmetic differences. Most people don't know the difference. Makes them harder to locate on eBay but you can usually get them for cheap. (I own 2 recapps and a Majesco)

Thanks for the reply. That 0 Ohm resistor is just so small it's hard not to pull up one of the pads up. I'm surprised I managed to do it all in one try in a couple of hours. I Soldered the pin connector in one shot without a single screw up. I have soldering experience, but this has to be the finest soldering I've done. I never did find that missing spring, I had to make a new one (cut and adjusted a 0.50 cent spring from the hardware store) Now my power button is just a bit stiff. I also found the flashback does not like to be used on a 72in 1080p LCD =P Was cool playing pong & combat on a 72in though.

Never mind. Connected it to R10 and both the cart and roms work, but I just dropped a spring and have dark carpet. -__-

I have it all soldered except the switch. (soldered the pin connector while waiting for switch in the mail) Went to solder the switch and knocked off one of the solder pads on J9. Is there any where else to solder to or do I have to scrap that whole board? Thank you in advance.