I've been following this discussion since about the beginning But now I have a question. Where is a good source for the GW1NR-9C boards? I think I have a bad one. Was all excited to get the parts and do some soldering this weekend. But first I tried programming the FPGA. Everything looked to go well. But nothing on the TV, it would just say no signal.
Here is the chain of events.
Downloaded and installed the education version of the GoWin software.
Connect the FPGA to know good USB-C cable.
Started the programmer software and it discovered the FPGA board.
Configured it to use this board, embedded flash, 2.5 Mhz speed, the .fs file from the repo.
Selected the program/configure.
All went well and was all blue text.
Plugged in the HDMI cable and nothing.
Thanks in advance for any suggestion on a good source for the GW1NR-9C. Or any suggestions on what to try with this one.
David