OK, this may be a stupid question ie electronics 101, but I have something that's really stumping me. I purchased a cap kit and was removing c521 from the power board and just for the heck of it I tested continuity with my multi-meter across the + and - and received a beep. I check a couple others and they don't do that. I'm wondering if a cap is removed, then the + and - shouldn't be connected correct? Does this mean I have a short somewhere else on the board? I check in the area for possible wayward solder that may have crossed a couple traces but i don't see anything. I have added a photo of the pads where I put each end of my multi-meter to test continuity.
Thanks for your help. Want to get this thing back to its former glory!