arcadeshopper

Texas Instruments Rs232 cards are worth 20$ ea to me, I'll buy any you find. Also always interested in myarc cards, any of them.. and corcomp disk controllers.. anything unique (not ti, myarc, corcomp) is also interesting. Pboxes are heavy and tough to ship, too bad they won't fit in a flat rate box I know a couple people that could use one, preferrably with 32k and flex cable card.. Greg

any cards?

http://home.vodafonethuis.nl/fgkaal/Modules/mod_create.html#module_creator Make any EA program files into a multi module Greg

Any word on more boards? I'd like to buy two Greg

We should pin a post with just your manuals

me too me too!

Ok if it boots without the dsr then that trace is cut.. There must be another issue. Are you leaving the PC plugged in? Try booting with the pc unplugged if so.. I had a prob the other day with my tI locking on boot and it turned out it was my PC not responding to hdx because it had locked Greg

Ok it seems to save the entire program now.. however it won't run.. garbage on the screen.. It runs fine from cassette if the 32k is there when I load it... I tried the same file with and without 32k and it gives me the garbage without 32k and works with 32k enabled.

ok that must be my problem then..thanks! I'll try that

Ymmv, the cheaper ones are usually not so good.. I know Owen used one with his TI and it worked ok if you plugged it in a few times.. Greg

Only if it is identical to the internal card. I haven't seen one, but I'd seriously doubt it is the same hardware in the same locations. ymmv might be able to figure out the jumpers, resistor and interrupt changes required but I would be suprised if it was simple.

I was asked to look at converting minipede to cassette. It loads in minimem or EA opt 3.. with a start name of START (load and run) I tried loading it in MESS then saving the memory space of the minimem (7000-7fff) to cassette but that didn't get the whole game.. I loaded in Classic99 and see the START in the memory around 8FD8 .. but minimem won't let me save memory past 8F00 Any ideas? Greg

Did the guy that put it together remember to cut the interrupt trace? no 5 on this photo http://home.vodafonethuis.nl/fgkaal/Hardware/hw_ti99hdx_card_rs232.html The trace needs to be cut for the card to allow the TI to finish the bootup routine with a bad DSR Greg

Last time it was $8 ea with $5 shipping via USPS in the US. This is just the PCB, no electronics or sockets installed.

When you see what looks like a violin on the road, hit it, that's the gun.. Then you can fire makes clearing traffic easy! Greg

On a real TI.. I get this on level 3: After I lost it went back to the clear screen for level 1/demo Greg

Preorder is now open.. http://www.arcadeshopper.com/wp/?page_id=11#!/~/product/category=5051340&id=21147033 Greg

I can manufacture in the US.. just sayin Greg

doh but now i can't change my vote!

you left off "I used to be a coding wiz but then i got a job as a network engineer"

See http://atariage.com/forums/topic/216844-3d-printed-objectscases-carts-for-the-ti/?hl=+3d%20+print

Any update?

What he said. . You will need a floppy on the TI side to copy the image too Greg

man we're old!

I did 3 messages up