Thanks both of you for the advice. I have it apart so I'll give it a really good clean with isopropyl. Are the Proms the one with the heatsinks on them or are they the ones that are four in a line? I just bought some detoxit and I applied it to the Colecovision slot and some of my carts and that works well to make the port more consistant. I'll try it on all of the pins since I have it available. I get a bit nervous using detoxit on the board itself so I'll just use the isopropyl for that.
On another note, I already built a new power supply and I have tested all of the inputs both from the power supply and from the wires coming into the system and they look right, so at least power should be good.
Also, I did try each of the data drive separately, but they don't do anything. I still think it is because the system is not really getting to the boot section on the Adam. Both drives could be bad, but I'd bet if I can get it to boot to Smartwriter, they will start working.
Thanks all!