mickcris

Doubt there is going to be a prototype any time soon. Just saw someone mention that they are using indegogo now. Most likely due to prototype issue. http://www.retrovgs.com/f.a.q..html When is the Indiegogo Campaign Happening? We are launching the RETRO VGS via Indiegogo the week of September 14, 2015.

replied to your pm, but ill post this here also: duojindance has a couple videos where he does a complete install on a Duo-R. you can get it from where he shows, or anywhere else there is 5v. You can use the output pin on the 7805 to check for continuity if you want to use a different point than what he does. I cant remember exactly where he gets it from.

Maybe they should have thought about this back in January

bump

I doubt it will make it past the kickstarter, especially now. I forsee lots of different colored Jaguar shells available in the future to try to recoup more funds for this. Although most of the buyers may be burned out already on the Jag aftermarket shells.

bump

bump. have lots of cables and amps ready to ship

http://atariage.com/forums/topic/236988-lynx-rewritable-multigame-cartridge/?p=3243025

I agree that "likes" are meaningless. that was my point although i guess i did not word it very well.

Somehow they have "11,682 Total Page Likes" on facebook so maybe they are thinking all those people and more (people not on facebook or haven't heard of it yet) are going to buy one.

bump

not that it really matters but for some reason it only works if you click here 1st: http://www.mmmonkey.co.uk/pc-engine-rgb-mod/ then click that link: http://www.mmmonkey.co.uk/wordpress/wp-content/uploads/2012/09/PCE-RGB-pinout-bus.jpg I guess its saving it in the cache or something.

You can send a message to their support and hopefully they would give you an answer [email protected] or if you ask this on nintendo age in the help wanted section, maybe bunnyboy will answer you directly

the link works when i click on it. its just a picture of the pc engine port to show that the RGB pins are on the opposite side. Its a picture from the guide i had linked to a few posts above and the ports are the same pinout on the outside when the consoles are back together.

its the same, but since the tg16 board sits upside down in its case and the pc eninge boards all sit upright, the pins you solder to are on the opposite side. see this: http://www.mmmonkey.co.uk/wordpress/wp-content/uploads/2012/09/PCE-RGB-pinout-bus.jpg so i think the board would have to be slimmer to work, or a new board would need to be made for the pc engine. also rgb does pass though the port. I have modded a couple PCE briefcase units, Ten No Koe 2's, etc..

Yeah, whether or not its your actually problem, you should replace it as it is bad or going bad. Is there some brown crud on the top (it sort of looks like it)? If it is, it probably has a hole in it.

bump

Can you see the cap from the guide i linked to with the amount you have apart now? Its part of the power circuit. See if the top is bulged like here: http://www.markdigital.com/wp-content/uploads/2011/02/bulging_capacitors.jpg you may have to break out a voltmeter and see if you have voltage going into the 7805 voltage regulator and also 5v coming out.

maybe the 2200uf cap went bad http://www.racketboy.com/forum/viewtopic.php?p=475289 if its something with the power, then its probably inside the console since it did the same thing with a genesis supply.

the rgb board looks nice. it looks like it might be too big for the pc engine, have you tried to fit it in one? since the port is upside down on the tg16, the board would need to be on the other side of the pins on the pc engine. http://www.mmmonkey.co.uk/pc-engine-rgb-mod/ eidt: nevermind, i think you meant that to use it you would have to run wires to the points on the board.

Have you tried both RF and AV outputs?

it works to power a NES. Not sure why you were told it would not. The Genesis PS puts out over an amp which is plenty. Sounds like its not the power supply then.

Do you have a Genesis Model 1? you can use the power supply from it on the NES to test if the power supply is the problem. Dont do it the other way around though as you will hurt you Genesis with the NES power supply.

you can still get the white ones on ebay http://www.ebay.com/itm/Atari-Jaguar-new-White-Plastic-Console-Replacement-Covers-/110804896487 http://www.ebay.com/itm/Atari-Jaguar-Custom-Painted-Plastic-Console-Replacement-Covers-White-Base-/111498788611

Did you contact the seller? You probably could have got a partial refund from them.