olix

Ist ist still possible to buy a Pokeymax V3 (Stereo Auto)? I wrote a PM to Duddie, but geht No answer.

Just to be absolutely sure and not to make a mistake: I only need to do a solder between 1 an 8 of U12? I really don't need a connection between pin 5 and 6 of U12? In the original circuit diagram from HIAS, this is expressly listed in note 1, if no battery is fitted. Otherwise the connection between the GAL (pin 18) and the memory chip (pin 22) would be missing.

I would like to buy one or two SIO-Sockets fpr soldering in my new XE-PCB (Atari 130XE Remake - Atari 8-Bit Computers - AtariAge Forums). Is this still possible? (I am from Germany)

I would like to buy one or two SIO-Sockets fpr soldering in my new XE-PCB (Atari 130XE Remake - Atari 8-Bit Computers - AtariAge Forums). Is this still possible?

In the original schematic of the 512k extension from hias is a note, to set two connections if you don't use the battery and the DS1210 IC. If i don't use U12 (MXD1210) should i set two jumper on the empty socket of U12 (1-8 and 5-6) to set the two bridges like in the digram?

The Ferrite Beads (2Ohm / 5) are currently not available at mouser. Not again until December. Is there an alternative for this? Can I use Beads with other values? like these: 40X FRH035060-A Ferrit: Perle [email protected] 100MHz: 60Ω Montage: THT [email protected] 25MHz: 30Ω FE | eBay or https://www.reichelt.de/emv-ferrit-entstoerfilter-axial-21-ohm-10-mhz-bead-8-21-p105526.html?&nbc=1&trstct=lsbght_sldr::7112

Is it still possible to buy a Pokeymax V2 Stereo Auto? I wrote a PM to Duddie over a week ago, but i didn't get no answer.

On the pcb (Abbuc-version), three 4,7 uF "Bipolar" Caps are drawn (Tantal?). Also in the Component List. But in your mouser basket are three normal Elecrolytic Caps (not bipolar) 4,7 uF listed. What should i use: Bipolar or normal Elko?

What kind of transistor is Q3 (npn or pnp)? The lettering for Q3 is missing on the mainboard (abbuc version).

Lotharek has a 64KB SRAM module that replaces base ram of 64KB in all 8bit ATARI. So you don't need the two 41464 RAMs. There is also a Freddy-replacement from Lotharek. SRAM 64Kb by Lotharek FREDDY MODULE by Lotharek Would it be possible, to use these two replacements with the new xe-pcb?

I would like two boards. (1x Atari400 , 1x Atari 800XL both PAL) - shipping to Germany. Is this still possible?

I am interested in one board.

Ich würde zwei Stück nehmen. Oliver

I'm interested in one.

... Still waiting here in Germany. I wish I could load the pdf version...