Eagle4Christ

Update: a connection problem. After some light pressure to make sure the pins were in touch, all is well. Thanks again!

Much obliged to you both!

Hello: Just got sidecar with TIPI (Pi Zero W connected) and SAMS, each with a separate power supply. SAMS runs 32k programs fine. I downloaded https://jedimatt42.com/downloads/tipi-sdimage-buster-2.28.zip and flashed it to an 8GB drive, which I put in the Pi Zero W. However, "CALL TIPI" in TI BASIC takes a long time to load--I've waited ten minutes without anything happening. I still have not seen the Configure tool. Is this to be expected for the first run? Sorry for the novice question.

Hello: The PEB I recently acquired has a dual 5.25 floppy set up. Both dsk1 and dsk2 operate when called upon (red light turns on, normal drive sounds occur), but only dsk2 reads data. Dsk1 returns an error whenever I attempt to read from or write to a disk. Do any of you have ideas where I might begin to diagnose and fix this problem? Is it time to chuck it in for a disk emulator? Much obliged. Sent from my Pixel 5 using Tapatalk

Munchman through 20 levels could be a fun speedrun Sent from my Pixel 5 using Tapatalk

Turns out this was it. After a minor adjustment, the button pops on and off easily. Thanks again. Sent from my Pixel 5 using Tapatalk

Thanks! If the quick fix suggested above doesn't do the trick, I'll post a pick. Sent from my Pixel 5 using Tapatalk

I'll try this before surgery! It just arrived via mail, so this is very possible. Sent from my Pixel 5 using Tapatalk

Hello, all: I recently acquired a PEB with a push button on/off switch. The switch is stuck in the on position, so I plan to replace it with a simple toggle switch. Do any of you have advice? It's seems straightforward to me, but I have not worked with the PEB before. Sent from my Pixel 5 using Tapatalk