Retro_Game_Lover96

The cable of for the PVM monitor has a direct connection, so it works fine with other systems that have RGB mods like the NES.

The Scart plugs into the PVM monitor with the Scart to BNC connector cables.

Here are the voltages from the sync output with the different options.

I wasn’t talking about your question, I was talking about something that has an extra potentiometer that was pictured.

Look at this picture. The citrus3000psi RGB board’s sync doesn’t have a pot.

Ugh, it doesn’t work. -_- I tried to replace the R11 and R24 with the new 15k ohm resistors, so their code is 18C. 18C = 15k Ohms BTW, I don't know the 153 and 18C are the same thing for 15K Ohms or not.

Yes, both R11 and R24 are 18 , so I have to replace them with 15K.

I was right, 153 is basically 15K Ohm resistor SMD.

Besides, they have to be 15K Ohm resistors to get the sync to work. BTW, I wonder what they look like? They are small that should have the resistor code, 153.

Well, do I have to replace it?

I don't know this'll work for the Sync fix for the RGB mod. By the way, I have a composite mod like this.

I am trying to get the RGB mod to work, I got full RGB, but how do I fix the sync?

I can tell that they’re the same thing.

I got it working on the PVM, but the sync issue and all green, so any ideas how to fix?

On the bright side, I did fix my ColecoVision after the 5v mod, but I am still trying to get the RGB mod to work.

I tried to check the voltage. I did the other side of the SMD.

The R23 has the SMD resistor code, 562 which is 5.6k Ohms. While the OSHPark says 5K6.

Didn’t you see my work about the mod board I install? Did I do it right?

I see.

Oh yeah, that would work. I think the Coleco’s vdp chip could be either TMS9918 or TMS9928. ”2” takes YPbPr while “1” takes composite only.

Cause if it is, it can be used because the SNES multi out takes RGB.

How do I adjust R23 because my RGB board doesn’t get a sync. Also, is it possible to use the SNES styled multi out connector for the RGB mod?

I was trying to test before mounting the RGB output connector to be safe. The bright side is, the grey scart cable works on my RGB modded 2600.

So, I guess the grey cable sucks, and I need a different SCART cable? Did I install the board correctly?

I am having the hardest times to get the RGB mod to work on my ColecoVision. I got no sync at all.