Search the Community
Showing results for tags 'ultimate1mb'.
Found 1 result
Hi, I'm very new in this Side2 + Ultimate 1MB world (literally, I just got it 2 days ago and installed it yesterday), so this may be a stupid question, but I cannot figure it out: My setup: 65XE (no ECI), Sophia rev.C, Rapidus, Ultimate 1MB, Side2 Configuration: Rapidus: 6502C Ultimate 1MB: 1088K, XL OS 1.3, SpartaDOS X disabled, Boot to Loader disabled, PBI BIOS disabled Side2: switch down, CF SanDisk Ultra 16 GB When I boot the computer, I get this screen: that seems to imply it is detecting some CF media. Because this is the first time using this CF, I ran FDISK, go to Initialize and I get: I After choosing that device, I get this screen: I enter some values in FAT and APT, it goes to a confirmation screen, press Save and get a message saying that the disk requires initialization. If I go to the Properties option, I get: Any ideas on what could be happening? Is the CF card not being recognized properly? Is there are a limit in the size of the CF, and 16GB is too big? The same CF, in Linux, works fine. In fact, I created a FAT32 partition, copied some ROMs and ATRs but, when I start the computer with the same configuration, but the SIDE2 switch in the up position, the Side Loader says "No media". Thanks for any tips and info! Andres. P.S.: I just tried the LSDEV command, and I get: Device: 2.0.1 Media: Controller: SIDE Driver v.4.0 Size: 0KB 512bps the LSDSK command says "No devices found"