Who can make a new trace on a CX-40 Board?

[toymailman]

I would like to make a new trace on a Board that fits in a CX-40 Joystick. My goal is to use a CX-40 on the Arcadia 2001 system. I did a mod of a CX-40 for use with the APF M1000 system, but the Arcadia will require a lot more work than that.

 

I scanned a CX-40 board and then drew a trace on the image that can be made to work (with the right pin connections). It is below. Can anyone have a few of these made for me? Thanks!

 

[toymailman]

I have tried contacting Best Electronics to see if they can do this. If not, is there anyone else someone can think of?

[AAirhart]

Get a trace drawing pen, scrape a little masking off and draw the new trace from that point.

[+save2600]

Did this back in High School - pretty simple stuff:

 

http://fritzing.org/learning/tutorials/pcb-production-tutorials/diy-pcb-etching/