SIO2SD and real 1050 drive don't like each other?
There is a problem with SIO2SD together with my 1050. Or maybe I'm just stupid
1050 is set as D1: because I want to boot from some old disks.
SIO2SD does not react if SIO2SD D1 is empty and I can boot from a floppy, so no problem at all.
But If I boot from SIO2SD and then remove the disk image from SIO2SD's D1 and add another to D2, SIO2SD does not respond anymore. The 1050 keeps responding as D1.
So how is it possible to boot selectively from Sio2SD (as D1) and then read Disks from
The original 1050 Turbo highspeed code had a check in there so that only D1: was accessed in 1050 Turbo mode. If you wanted Turbo mode also on D2: or higher you had to change this manually. Here's a code snippet of the highspeed routine:
0122 LDA $023A
0125 CMP #$32
0127 BCS $014BIIRC TurboDos had some special autoexec commands so you could enable 1050 Turbo mode on other drives automatically on boot. But I never used this as I only had a single 1050 Turbo.
I'd suggest the SIO2SD code should
