Jump to content
oryan_dunn

Disk drive adjustments, floppies not compatible between drives...

Recommended Posts

tl;dr:

I have 3 drives, all 3 drives have speed set to 199.8ms-200.2ms via the Copy ][ Plus program.

 

Floppies formatted in drive A work fine in drive A, disks formatted in drives B and C work fine in drives B and C. Are there any other adjustments to make to bring drive A in family with drives B and C?

 

 

body:

I had earlier asked for advice on programs that could test floppy disks and got some suggestions (http://atariage.com/forums/topic/262456-any-floppy-disk-check-programs/).

 

A bit of history. The three drives mentioned above when I first started working on these:

A: Apple Disk ][ with Drive 1 sticker (made lots of noise, didn't seem to read any floppies)

B: Micro SCI with Drive 2 sticker (seemed to work fine)

C Apple Disk ][ without drive sticker (only seemed to spin the disk)

 

I started using ADTPro and created a few disks using the drive A. Those disks worked fine in drive A only. All existing floppies only seemed to work in drive B.

 

Then, I was an idiot and somehow managed to break both drives A and B. After looking around, it seemed I needed new 74LS125 chips. A few days later and a dozen new 74LS125s, I actually got all 3 drives working. Turns out, drive C had a bad chip as well, in fact, when I removed it from the socket, the bottom of the chip fell off. It was well and truly smoked!

 

So, will all 3 drives working and the heads fully cleaned, I used Copy ][ Plus to check things out. I got all 3 drives dialed in to 200.0ms as close as I could. Drives B and C seem to be 100% compatible and seem to read old floppies and new floppies written on drives B and C just fine. Drive A works only with disks written on drive A.

 

Are there any other adjustments other than drive speed that I can adjust to get drive A working?

Share this post


Link to post
Share on other sites

Hi,

You should take a look at speedyG's Disk II webpages.

It shows all the possible tuning you can achieved.

 

It seems your drive A has a misaligned head. This kind of setting is tricky.

 

This seems like the most reasonable explanation....

 

I use Copy ][ Plus to check and then change my Drive Speed, if needed...

 

MarkO

Edited by MarkO

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...