GameGear1909 #1 Posted November 18, 2017 First of all, Hello everyone, i'm new in this forum. Recently I've bought a Mc will mod for Game Gear and I have a problem: When I press 1 and 2 buttons at the same time, the screen change its scale. Normally this only happens when you press 1, 2 and start button too at the same time. Does anyone know if it's possible to fix it?, becouse is a bit annoying because some games needs to press 1 and 2 bottons at the same time. Thank you in advance. Quote Share this post Link to post Share on other sites
mobiusstriptech #2 Posted November 19, 2017 It sounds like you have bridge or you soldered to the wrong point for Start. 1 Quote Share this post Link to post Share on other sites
GameGear1909 #3 Posted November 20, 2017 (edited) It sounds like you have bridge or you soldered to the wrong point for Start. Thank you for your answer. I post some pictures about it, just in case someone could help me. Thank you in advance again Edited November 20, 2017 by GameGear1909 Quote Share this post Link to post Share on other sites
mobiusstriptech #4 Posted November 20, 2017 Button 2 is connected on the wrong side of the cap. Switch the wire on c30 to the other side of that cap and give it a shot. 2 Quote Share this post Link to post Share on other sites
GameGear1909 #5 Posted November 21, 2017 Button 2 is connected on the wrong side of the cap. Switch the wire on c30 to the other side of that cap and give it a shot. Yes mate!!! You were right!! I did what you say and it's fixed, so I want to thank you very much for your help. Quote Share this post Link to post Share on other sites
mobiusstriptech #6 Posted November 21, 2017 Yeah not a problem. Glad that fixed it. I need to take better pictures of both 1ASIC and 2ASIC models and make a slightly easier to follow guide for people doing the McWills screens. I have seen others run into similar issues before. Quote Share this post Link to post Share on other sites
cowdog360 #7 Posted June 22, 2018 I like the install you did with the wires rather than using the old LCD connector.. where did you find pinouts/instructions for those? Thanks! Quote Share this post Link to post Share on other sites