Feedback requested
11 members have voted
-
1. If i were to make this a physical item how would you liketo receive it?
-
In kit form so you can build it yourself
-
complete so that it can be used straight away
-
release documentation and schematics so you can obtain the parts yourself and build it yourself
-
-
2. Is having two payer compatability important to you rather than obtaining two one player devices
-
1 player is fine, i dont have anyone else to play with anyway
-
i dont play 2 player enough to give a toss
-
i play 2 player regularly, so this is a must
-
-
3. after trying multiple ways to try and steel enough power from the joypad port it is not possible. how ould you prefer to power these devices?
-
i dont mind soldering a couple of wires into my colecovision to provide power
-
barel power connector that is used on the jaguar / nes / snes / megadrive power supply
-
rechargeable lithium ion battery
-
provide pins for users to attach their own power supplies to
-
-
4. I have been working on this for quite some time now so hopfully all the bugs in the code have been found but would you
-
like the ability to reprogram the device when new firmware when / if it becomes available (small purchase of a icsp programmer needed) or if you have an arduino uno, use that
-
fit the main processor into a socket so that it can be swapped out for firmware update etc
-
dont bother, i trust the code is fine
-
-
5. would you prefer if the device was the same footprint as the joypad holder indent
-
yes this would save having extra devices sitting around th device
-
no i am happy having the device sat on the floor next to the colecovision
-
make it as small as possible
-
not bothered
-
-
6. currntly the prototype is a one player board (arduino uno based), if two payer are saught after do you mind having a board with two lots of one player components (arduino uno) to make 2 players or is it preferred to move to an (arduino mega)
-
if this is the easiest option use 2 lots on 1 player parts, as long as it works i dont care
-
no it should be re written to use a processor with more pins to enable more electronic functionality even though it is surface mount an more difficult to manufacture0
-
-
7. do you think it would be useful to be able to change the coleco L and R fire buttons around over the jaguar CBA fire buttons
-
juat leave them preset to C B for L and R fire buttons
-
juat leave them preset to B A for L and R fire buttons
-
juat leave them preset to C A for L and R fire buttons0
-
allow the user to select which buttons they want to assign to L and R fire
-
would it be useful to allow L and R fire to be swapped so that L is on the right of the jaguar pad and R is on the left CB would be RL for example
-
-
8. If this project was convertd into an arduino mega shield requireing the ownership of an arduino mega or clone would this be acceptable
-
no, i need a stand alone board
-
yes i already have an arduino mega and i am happy to use this as a base for this project0
-
sounds like a good idea to me as it already has the programming hardware for firmware upgrades already built in
-
- Please sign in to vote in this poll.
-
Recently Browsing 0 members
- No registered users viewing this page.
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.