sethbramwell Posted March 12, 2019 Share Posted March 12, 2019 Hi everyone, This may be a very stupid question but I cannot seem to find a definitive answer for the life of me and Google seems to give contradictory results. I am modding a Flashback 2 to install the cartridge port. I have located the solder pads but my question is this: Do the numbers on the pads correspond to the pin numbers on the cart connector? I think logically that they would, but I can't seem to find answers and searching for pinouts of the cartridge port seem to indicate that they would not simply match up due to what each pin is labeled as (A7, D0, etc.). I just really don't want to brick this or go through all the work only to have to rip it all apart again. Any help is greatly appreciated. Thank you in advance! Quote Link to comment Share on other sites More sharing options...
bah Posted March 12, 2019 Share Posted March 12, 2019 This should be helpful. Note the label direction for the cart connector. There are 3 FB 2 board variations so your solder points and jumper points may not be in the same locations. Quote Link to comment Share on other sites More sharing options...
sethbramwell Posted March 12, 2019 Author Share Posted March 12, 2019 Thank you, I did download that image as well. I was just concerned because of a pinout diagram that did not seem to match the pinouts listed on the board, but upon closer inspection I think I was reading it upside down. Oops. Thanks again! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.