Bagpuss Posted March 12, 2019 Share Posted March 12, 2019 (edited) Hi All, Just wondering if anyone has seen a Lynx 2 with an RF shield that covers the entire underside of the Lynx? I want to recap the board and install a McWill screen, but I can't see how to remove the shield without taking cartridge slot off (which I don't want to do, even if I could). It won't just lift off once unsoldered, as the legs of the cartridge slot prevent this. Would it be okay to just cut the shield? Thanks, Andy. Edited March 12, 2019 by Bagpuss 1 Quote Link to comment Share on other sites More sharing options...
Krip316 Posted March 12, 2019 Share Posted March 12, 2019 Yes, I’ve seen a few. Quote Link to comment Share on other sites More sharing options...
+-^CrossBow^- Posted March 12, 2019 Share Posted March 12, 2019 Yeap..I did a recap and McWill on of these not that long ago. You have to remove all the solder from it and that will at least allow you to lift it up as needed to get the solder points underneath it. For the McWill installation I cut away that shielding around the connector pins to expose that so it wouldn't be an issue. Quote Link to comment Share on other sites More sharing options...
LX.NET Posted March 12, 2019 Share Posted March 12, 2019 What is the part number on the board? 1 Quote Link to comment Share on other sites More sharing options...
Bagpuss Posted March 13, 2019 Author Share Posted March 13, 2019 What is the part number on the board? Part number is C104424-001 Rev. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.