Jump to content
IGNORED

Any must do mods for the Jaguar?


Diederikgr

Recommended Posts

Uhm, maybe not the answer you seek, but for quick testing you can use Super Burn out. Check if the speed is measured in MP/H (60Hz) or KM/H (50Hz) and see if that changes when you start the Jag after you put the switch in the other setting. No need to find the right spot to measure things unless you have to trouble shoot where things are going wrong.

 

Link to comment
Share on other sites

On 8/16/2019 at 10:38 AM, Zerosquare said:

Check that you have identified the right resistor, removed it and that the soldering is correct (no cold solder or short-circuit).

There's very little that can go wrong if you follow the steps.

"Maybe" (for sure) I did bad soldering, it takes me 10 to 40 minutes to do a soldering so I'm not very good at it. 

On 8/16/2019 at 4:25 PM, Ayreon said:

Uhm, maybe not the answer you seek, but for quick testing you can use Super Burn out. Check if the speed is measured in MP/H (60Hz) or KM/H (50Hz) and see if that changes when you start the Jag after you put the switch in the other setting. No need to find the right spot to measure things unless you have to trouble shoot where things are going wrong.

 

Tested with Super Burn Out and it works.

22 hours ago, swapd0 said:

Also the left point above R140 shares the same line.

This is wrong.

7 hours ago, Zerosquare said:

Yes.

Yes, it works. I've used that point.

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...