Geneve 9640 DIN Video to DB9

[Shift838]

I was thinking for all the Geneve users out there that may have a RGB monitor and hate soldering the din connector to cables.

 

So... I came up with this.  a standard din 8 pin that is used on cables will solder directly on one side and on the other a  DB9 Male.  Plugs right in to the Geneve then you can make your own cables easily with db9 connectors.

 

 

 

 

 

 

 

Edited June 18, 2019 by Shift838

[+Ksarul]

Definitely a good idea. . .

[Shift838]

I have ordered a few.  a Geneve'r will need to make their own cable for the DB9 but it's a hell of a lot easier than messing with the DIN connectors.

[Shift838]

I got the test boards in.  Put one together and decided to interface it with a GBSGenie EVPC board with a GBS8200 since I had an awesome case for use for the GBS8200 from Corei64 (HERE).  I just had to drill a hole for the audio pigtail.

 

the DB9 converter board fits nicely on the back of the Geneve video socket.  I have used a small pigtail for audio.

 

See pics.  It works great with the Geneve.  Good clear picture and hooked up VGA!

 

 

[Shift838]

I have a couple of these DIN to DB9 boards available.  $7.00 + shipping (assembled/tested).  great for converting your DIN8 to a DB9 for use with a DB9 based RGB monitor or use  your Geneve with a GBS8200.

 

PM me.