New SDrive-MAX cases

[JohnBlbec]

On 5/17/2020 at 1:18 AM, tajvdz said:

Yes this looks good!

 

what I have so far is the enclosed file but it doesn't have the gaps filled.

The file I have has the stylus holder on the other side, but I think this is much better.

 

The lead hole on that side yes but not at the bottom but a bit higher.

 

What is missing in my stl file are holes for the 2 leds and the switch. I think the only place to put them is on the front. Leds left of the Atari logo and switch right of the Atari logo. 

 

So I think if you continue with your file is to add the text on top and the logo on the front and move the hole for the lead a bit higher and center it between the 2 connections. And at last to add a hole for the switch with the letters S and E and 2 small holes for the leds. I do have an example of the switch. It was done on another case.

 

SDRive Max Case Tweaks-3.stl 354.77 kB · 65 downloads

hi. do you have that case also for arduino board with micro usb? i can't find it. thanks.