Jaguar cartridge slot cover .STL?

[amiman99]

Here are 2 models that are aligned.

I made the logo and slot cover hole same height at 2 layers when first layer at .35 and others are .2mm

Use this link to show you how to merge them in Cura: https://support.ultimaker.com/hc/en-us/articles/360011738340-How-to-merge-and-group-models-in-Ultimaker-Cura

Let me know if it's better.

 

I wish I had Red filament so I can do it myself.

 

jaguar-slot-cover-aligned.stl jaguar-logo-aligned.stl

[mmbe]

18 hours ago, amiman99 said:

Software says it's 14g, my scale says 13g. About 1hr print time. Print at .2mm or .3mm layer height.

Good price.

 

Thanks for the information.

[KevinMos3]

On 7/30/2020 at 2:04 PM, amiman99 said:

Here are 2 models that are aligned...

Let me know if it's better...

Printing now. So far it’s looking good. I have way better bed adhesion today and high hopes for this round of printing. I’ll post a pic if it turns out.

[KevinMos3]

I think I'm going to consider this a win.  Normally, the way my 1st layer prints on that textured glass bed, the lines are barely visible.  This time, I had the temperature in the gcode file lower than normal and didn't realize it until it was already printing.  I might try another round at a higher temp, but even with this, I can sand it down a bit and mist it with some satin clear.

 

Working much better with it perfectly aligned in Cura... and better bed adhesion.

Finished print.

[amiman99]

Looks nice!

If you sand it with 300 or better grid it will look nice and smooth.