Ti-99/4a keyboard label holder

[Ncvfg234560]

Does anyone know the dimensions of the label holder for the ti-99/4a. I am planning on making a 3D model and print ing it. I currently do not have one on my ti-99.

[kl99]

do you mean the Keyboard Strip?

[Ncvfg234560]

Isn't there a plastic holder where you can slip keyboard strips in and out?

[+Lee Stewart]

23 minutes ago, Ncvfg234560 said:

Isn't there a plastic holder where you can slip keyboard strips in and out?

 

Yes. It is 8 3/4" x 5/8" x 1/4" with a channel to hold a strip, 1/2" x 8 3/4". Actually, the strip is a little less than 1/2"—maybe closer to 12 mm, but you probably have strips to measure. Measurements were done with a ruler.

 

...lee

[Ncvfg234560]

Thank You. I will see what I can do...

[kl99]

 

from my usergroup collegue Tom from his page:

http://www.8bit-homecomputermuseum.at/computer/texas_instruments_ti_99_4a.html

[+Lee Stewart]

You should know, too, that the width is critical in that it fits into a depression such that, if it is too wide, it will bind the top row of keys.

 

...lee

[Omega-TI]

6 hours ago, kl99 said:

 

from my usergroup collegue Tom from his page:

http://www.8bit-homecomputermuseum.at/computer/texas_instruments_ti_99_4a.html

There are many others that some of the users have made and contributed over the years too.

They can be found <<HERE>>.