Jump to content
Sign in to follow this  
Goochman

STiNG Help

Recommended Posts

I bought one of those NE2000 cart port network cards many moons ago.  Every time I try to use it I seem to run into a mysterious problem that takes days to fix.

 

For the most part Im pretty sure Ive got the right drivers and control panel (v1.31) - I think it comes down to my route table for me trying to connect to a machine on my local network.

 

My network is 192.168.1.x

My Gateway is 192.168.1.1

The hard wired IP address for STiNG is 192.168.1.58 which appears open from what I can tell on my network

 

I believe the ROUTE.TAB is my issue as if I have things somewhat right the ACTIVE light will flash on the card when I ping.  If I make a mistake it seems the ACTIVE light wont flash.

 

Any thoughts on the right way to configure this?

 

Here is the ROUTE.TAB file and what I thought was right but obviously isnt.

 

#  Format of routes comprises four entries, separated by TABs :
#    - First the network (subnet number) which can be reached by using this
#       route.
#    - Next the subnet mask associated with that network.
#    - Then the port name follows. This is the name as listed by ConfSTinG or
#       STNGPORT.CPX.
#    - Last entry is the IP address of a host on the attached network that 
#       can act as a gateway.
#
#  The network specified can be directly attached to the specified port, in
#  that case no gateway is needed, as the datagram can be routed directly.
#  For a route to a network that is directly attached therefore the gateway 
#  entry should be set to 0.0.0.0.
#
#  For an attached Ethernet the gateway entry specifies the gateway out of 
#  the Ethernet, for a serial line it is simply the host at the other end.
#
#  It is advisable to finish the table by a default route. This route is most
#  easily obtained by specifying a network 0.0.0.0 with a netmask 0.0.0.0.
#
#  Routes with invalid addresses or absent ports are ignored.
#
# 192.68.0.0        255.255.255.240        Modem 1        192.68.0.1
# 130.75.75.0        255.255.255.128        Ser.2/LAN    0.0.0.0
# 0.0.0.0        0.0.0.0            Ser.2/LAN    130.75.75.16
#

192.168.1.0        255.255.255.0        EtherNet        192.168.1.1
0.0.0.0        0.0.0.0        EtherNet        0.0.0.0

 

Ive also tried

0.0.0.0        0.0.0.0        EtherNet        192.168.1.1

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...