Terminal software for ESP01 on nanoPEB?

[monzamess]

Hi, long time reader/first time (?) poster (in this section).

 

I recently acquired a TI, FinalGROM99,  nanoPEB, and ESP01 module. (plus a FlashROM99 because I misread an eBay auction)

 

For context, I haven't used a TI since back in the day when as a kid all I had was a console, tape recorder, and a couple of cartridges. So, figuring out how to move disk files to the nanoPEB, run programs, etc is all new to me.

 

I got as far as running ESP01/O and sending AT commands to the unit to connect to my WiFi router, per attached image. I tried a couple of times to connect to a couple of BBSs but only got the "error" response. Not sure if my ATD commands were malformed, or the BBSs were not responding, or what. 

 

What's next?

 

Is there a good Terminal program that works with this hardware set up?

 

 

Edited March 23, 2020 by monzamess
now in correct section

[WhataKowinkydink]

TELCO or MFM (Magic File Manipulator) will probably be your best bet.  I don't have a nanoPEB (yet ;)), but I think there is software that it comes with that you should be able to use. 

 

You can find TELCO here on whtech:

http://ftp.whtech.com/communications/

[monzamess]

I thought I read somewhere (here?) that the nanoPEB + esp01 still needed software support but like I said I'm still catching up with all that's been going on in the TI world.

 

I will check that out!

 

[jaybird3rd]

I moved this thread from "TI 99/4A Development" into the main 99/4A subforum.