3d printed rear fascia for Indus GT, LDW Super 2000 (& maybe Rana 1000)

[xrbrevin]

I recently acquired a broken LDW Super 2000 disk drive that has a few parts missing.

In the process of resurrecting it, i have designed a 3D-printable rear fascia that is approximately accurate.

the .stl file is attached in case anyone else can make use of it.

 

I dont have enough black filament so I printed it in purest green. I havent done any post-processing - this is straight from the print bed but it could do with a bit of filing down to get the lumps off the edges.

I attached it to the LDW drive (that has a distorted metal casing) and parked it on top of an Indus GT for visual reference.

It may also fit the Rana 1000 drive but I havent got mine to hand to test it.

 

 

 

IndusGT back panel.stl

[gilsaluki]

wow.  impressed.  Green with envy.

[xrbrevin]

cheers!

i think i will increase each radius instance to 2mm, they seem a little too sharp compared to the Indus GT's original fascia.. 🤔

attached is the .stl file with this amendment

 

 

IndusGT back panel2.stl