Jump to content
Sign in to follow this  
danwinslow

Fan/Heatsink for a CT60E 68060

Recommended Posts

Did you get an answer Dan?   I am preparing to install my CT60e and I cannot even figure out if the 2-pin header next to C45 is for the cooling fan, which side is positive/negative, and if it is 5V, 12V or something else.

 

Share this post


Link to post
Share on other sites

I ended up going with this:

 

https://www.amazon.com/dp/B07N5M94NT?ref=ppx_yo2_dt_b_product_details&th=1

 

And then replaced the fan with a 40mm x 10mm Noctua silent fan.   It was a simple swap out/screw in replacement.   The heat sink comes with an adhesive pad but I ended up using some artic silver thermal paste that once it dried had bonded to the top of the CPU quite well.   The unit has been running without an issue so far, but I am at stock 66Mhz and have not tried any overclocking.   

 

For the benefit of anyone else looking to install a CT60e, the two pins next to C45 on the last CT60e revision are indeed 12V/GND for a fan.   The 12V pin is closest to the cap.

 

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...