+dhe Posted November 15, 2021 Share Posted November 15, 2021 Shift838 was instrumental in my getting the card going. I just got an IDE setup going and thought I'd type up a few notes while it was fresh in my mind. Before you get started go to Fred's website: https://www.ti99-geek.nl/ You'll need disk versions of his: DSR, DU2K and DM2K. You can set the CRU for the IDE controller any place, the DSR isn't picky. Make sure you don't use slot 5 in the pbox. In my case, I'm not concerned about DSK1. emulator, so I set mine up as >1200 - right behind the FDC. Do yourself a favor: purchase an assembled unit from Shift838 and have him add and format a CF drive. Two potential pain points on the IDE controller is the CF adapter needs to pull memory from the controller, which can wiggle loose, so I taped both the red and black wires down with a small piece of electrical tape. Chris added an LED by the compact flash adapter, if the LED isn't lit - then the CF adapter and CF card isn't getting the voltage it needs to run. The other pain point is the DSR is stored in RAM, so it's possible for that to get hosed - just like on a Horizon ramdisk. Now the nice thing is, even if your DSR becomes toast and you have to reload the DSR - the partitions living on the CF will be seen and you don't lose a byte or bit of data. There is a switch on the back of the card that will disable the card. You can use that, if the DSR gets it, and you can't get to the title screen. Disable, get to the title screen and enable, reload your DSR. CALL IDEST - is your friend. 7 Quote Link to comment Share on other sites More sharing options...
+Schmitzi Posted November 16, 2021 Share Posted November 16, 2021 Hi, why not slot #5 ? 1 Quote Link to comment Share on other sites More sharing options...
+dhe Posted November 16, 2021 Author Share Posted November 16, 2021 Chris said so! ? That came from Thiery's original note. The placement of the voltage reg is perilously close to a big screw on the back plane. Quote Link to comment Share on other sites More sharing options...
+jedimatt42 Posted November 16, 2021 Share Posted November 16, 2021 Isn't the tab, and therefore heat sink, on a 7805 already electrically connected to GND ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.