shear_xear Posted March 18, 2022 Share Posted March 18, 2022 (edited) Hi everyone. I have installed the UAV mod kit on many 2600’s in the past, but this time I am getting no color. Perfect image in black and white, and the color switch is working (b&w “changes” when switched). The color pot alters the image slightly as well, so I don’t believe that is the problem. I have tried lifting pin six as well even though color saturation isn’t the issue. The board was producing color before the install, and I am connecting to the pins of the 10440 in the bottom of the board as I always have before. I swapped in a second UAV pcb which gave the same result, and even tried another working 2600 board which only gave black and white as well. The PCBs look fine (I’m not seeing any missing components). Anyone ever encounter this before? I am wondering if somehow it’s a bad batch of UAVs at this point, but I’ve never had a single bad pcb up until now. Thanks! Edited March 18, 2022 by shear_xear Quote Link to comment Share on other sites More sharing options...
shear_xear Posted March 18, 2022 Author Share Posted March 18, 2022 It looks like either the chroma or luma pin on the s-video jack was being grounded. I did check through the composite, so I must have not adjusted the pot enough to give color at that time. Thanks! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.