Jeremy Popp Posted October 12, 2017 Share Posted October 12, 2017 I'm looking for a little help as I've recently come across a set of Atari Wireless controllers with the receiver. Everything works, however my antenna has been broken in half at some point, and I'm missing the top half. I'm hoping someone can do me a favor and measure the length of an original antenna as collapsed AND extended fully as this will help me find a replacement. Thanks in advance! Quote Link to comment Share on other sites More sharing options...
nick3092 Posted October 13, 2017 Share Posted October 13, 2017 If someone doesnt beat me to it, Ill try and remember to measre mine when I get home from work tonight. Quote Link to comment Share on other sites More sharing options...
nick3092 Posted October 13, 2017 Share Posted October 13, 2017 (edited) Its about 4.25 inch collapsed and 18 inch extended. Thats from the tip to the bottom of elbow when bent at 90 degrees. Like in your picture. Edited October 13, 2017 by nick3092 Quote Link to comment Share on other sites More sharing options...
Jeremy Popp Posted October 16, 2017 Author Share Posted October 16, 2017 Its about 4.25 inch collapsed and 18 inch extended. Thats from the tip to the bottom of elbow when bent at 90 degrees. Like in your picture. Perfect, thank you so much. Now the hunt is on to find a suitable replacement. I'll be sure to post if/where/when I find one for future reference. Quote Link to comment Share on other sites More sharing options...
Jeremy Popp Posted October 31, 2017 Author Share Posted October 31, 2017 https://www.amazon.com/dp/B073FNS7R6?tag=60002a1-20 I found a really close replacement here. For future reference, if the link doesn't work, here are the details: 7 Section Telescopic Aerial Antenna FM RADIO ANTENNA Manufacturer: TS ASIN: B073FNS7R6 Section :7 sections First Section Diameter:7mmExtended length:450MMHight quality Material: BrassFit for Radio ,DAB Collapse length: 97mm The tip is not exactly the same, but the sizing for everything is amazingly close. I had to keep the base because it has a connector that I've never seen before. However, taking out the one Phillips screw at the hinge and replacing with this one was easy. I did add an extra washer because the new one is slightly thinner where it connects. Once collapsed, it will even snap into it's resting clip and looks original. Thanks again for your help nick3092 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.