NES frony loader INTO a top loader mod-
Aside from hacking up a 72 pin connector & soldering top 36 /bottom 36 to motherboard card slot... Anyone SUCCESFULLY do this modification? I have tried the soldering-huge mess, tought to make them not touch, not too secure, can't replace PIN in future without doing it all over again.
Because you cannot just cut the plastic & bend the 72 into a 90 degree angle due to the 2 seperate rows of pins, I have tried to pull out the pins that form the "U" on the back (just one half of them) of the 72 connector, cut away plastic, bend to a 90 degree angle, then reinsert the pins-does not sit correctly & a game would push them back out the back in no time at all.
I have read a post about using 2 floppy drive cables side by side. But using an old Amiga floppy cable would be female with another female. Has anyone succesfully done this WITHOUT soldering. Looking for a plug n play setup to make the NES-001 a toploader. ANY HELP, PICTURES, PROCEDURES would be greatly appreciated!! I know I just signed up here, but it seems some of you guys could help. Thanks.