dragonHunter

Please add me to the list for 2. Thanks!

Please put me down for one (disc/d-pad on left, as in the 1st pic of them in the box). Any idea on what shipping will be to USA? Thanks!

I'm using a SanDisk Ultra 32GB class 10. In Dragon's Lair, I'm consistently having the game crash very early in the fire ropes scene. What's odd is it always works fine if the scene is played with Dirk going from the right to the left, but crashes every time if the scene is mirrored. The scene seems to play 80% of the time starting from the left... Are they different video files or is a mirror effect applied? BTW, my Jag has a K serial number.

I'm having a weird problem where pressing B in the menu on any and all jcd files does nothing. I used the known-good set and converted them with no errors, but they just won't load. Non-CD games load fine. My Jaguar is a pretty early one, I think. My GameDrive has firmware v1.09, menu v1.06, asic v1.06, and stub v1.03. Oh yeah, my sd card is a SanDisk Ultra 32GB class 10.

I've been repairing my Colecovision with good success (new power switch, 5v only RAM, electrolytic re-cap), but suddenly started getting odd behavior. I saw the 5v coming out of my new power-switch was dropping ~ 0.6volts (the 12v side wasn't dropping much at all). I wound up removing the new power switch and going with thick paper clip jumpers for the 5v and 12v. Right after soldering them in, I noticed cap C70 was smashed down and its frontward leg was touching the solder point between it and the cart port. I'm wondering if that could have been the actual cause of the 5v voltage drop. Plus, the power switch never showed any resistance on either rail.... My Coleco ran properly after this, but with some occasional bad power ups. I much rather have a good on/off switch than constant wart-pulling, so to speak. And, it's probably not the best thing to be doing to the old PSU, anyway. Probably not needed, but I attached a pic of a motherboard like mine with the shorted points highlighted in red. Anybody know what effect this short would have? Was it the cause of the voltage drop? Thanks

I'd like to pre-order one.

I'd like to reserve one. Thanks!

Well, I hate to admit it, but the crashes were cause by me forgetting to put "PROCEDURE" after the label of a subroutine. INTYBasic didn't complain ... not sure if I should or not.... jk Anyway, thanks for the reply. Good to know about the .cfg file. And thanks for an easy way to get assembler quality stuff onto a classic system!

Has this been updated to work with INTYBasic 1.2.8? I noticed the .asm files are a bit smaller and older than the 1.2.8 ones. I'm working on a big game and starting out using the 42k example, but was getting a lot of random emulator failures (the emu would immediately crash when the game was started; even though I was careful with segment sizes). So, I tried your 40k cart.mac, and it seemed to fix the random emulator crashes. But a couple of days ago, they started up again. I'm hoping newer .asm files will have bug fixes that stop these crashes....