jmprice_314159

I have the Tom2, anyone know if there is any way to change the gamepad button configuration? The left trigger for auto fire was the worst possible choice of button, and I'd like to change it. Is it possible? I tried the "e4u Adapters Configurator" program and it doesn't do much, just shows the adapter is plugged in and the firmware, which is completely useless.

Can this be used to run 7800 games?

Hello fellows, might any helpful fellow here be able to assist a solder-challenged fellow? I'd really like a cable that can accept SCART and output to the Atari SC1224 so I can connect my various computers and consoles. I can pay a fellow for his efforts. I live in the USA. Thanks, Jason.

Ok, no problem. Thanks for working on it.

Any joy? did it work? Cheers!

Ok, when I run the ATR using the MyIDE II cart, it reports the SAVE was ok, but when I do a RESTORE, an error is reported. Don't know why. Any ideas? Cheers.

Hello, for the save and restore of a game session, do I need to have a physical floppy drive? Cheers, Jason.

Robocop has an issue in the first level: You cannot get through a door when 4 MB is used. When 1 MB is used I could complete the game. I remember a few other games having issues with 4 MB and worked with 1 MB, but cannot remember which ones. Cheers.

Is there a program that can change an STE memory from 4 MB to 2 MB? I know about the 1 MB program, but some of the games require 2 MB, and some of the games don't seem to work right with 4 MB. Yes, I could simply physically remove 2 GB from the STE, but I'd prefer not to. Thanks, Jason.

Ok, thanks. I found this on ebay: NEC µPD4164C-15 150 ns NMOS N.C. 128cycle/2ms But, the original MT chips have different cycles of 256: Micron MT4264-15 150 ns NMOS N.C. 256cycle/4ms No idea what difference that makes, and if NEC is good memory? Also, found this: T.I. TMS4164-20NL 4164 64K Dynamic RAM Don't know what "NL" means? Would TI be better than NEC? Thanks.

Ok, how do I get to post 205? Thanks.

Hi, I have a 130XE with bad ram. Can I use the SYS-CHECK V2.2 to simply bypass the bad ram and run games from my Ultimate Cart and/or MyIDE II cart? It is not clear from the youtube videos about that. Or, would I still have to desolder the bad ram and replace it? If yes, the SYS-CHECK V2.2 is a non-starter for me. Also, my 130XE has the expansion port on the back. If it will work, are there any in stock and where/how do I buy it? Thanks!

Hi, I have the same problem in my heavy sixer. Would this item work instead of what is mentioned in the previous comments? "Atari 2600 Drop-In A/V S-Video Composite Pause Mod Kit NTSC - Ben Heck" https://www.ebay.com/itm/313140300227 So, I wouldn't have to replace transistors, capacitors, and whatnot? I cannot do that type of soldering, but I could solder the wires for the board I mention above. Thanks

There are 16 chips.

Thanks for the reply, but I don't have the chips as I don't know which type to use, and per my post, I don't know which chips are bad from the picture I posted. Also, I don't know if Lotharek's 64K chip will disable the remaining 128K in the 130XE RAM.