Kirmo Posted February 14, 2008 Share Posted February 14, 2008 Hi All. Here the link to my project concerning an eprom programmer , with some features specific for Atari 2600 eprom. Considering that this is the first release (but system is fully working) , so any suggestions/impovements are welcomed. Very easy to build for a few dollars. Of course the schematics , firmware and software are tatally free and availabe Your comments are appreciated regards, Mirko Quote Link to comment Share on other sites More sharing options...
supercat Posted February 15, 2008 Share Posted February 15, 2008 (edited) Considering that this is the first release (but system is fully working) , so any suggestions/impovements are welcomed. I don't particularly like the use of DIP switches to control voltage. A simpler approach might be to have a circuit something like VDD ---IND---+--->|----+---+---- +18 out | | | | | | C | Z Pin --RES---B< Cap ^ E | | | | | VSS ---------+---------+---+ IND is a small inductor. The CBE thing is an NPN transistor. The Z< thing is a zener; the >| thing is an ordinary diode. The cap is to filter the 18 volts output. When Pin just sits low, the +18 output will sit at +5. When Pin is pulsed high at a suitable rate (experiment) the +18 will go up to the zener voltage. This approach will put some drain on VDD, but it won't require the +18 that your other design does. Edited February 15, 2008 by supercat Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.