Mehridian Sanders Posted December 8, 2019 Share Posted December 8, 2019 I don have anything but hair dryers Sent from my SM-G955U using Tapatalk Quote Link to comment Share on other sites More sharing options...
Mehridian Sanders Posted December 8, 2019 Author Share Posted December 8, 2019 Ah well... not much can be done really.. but dang!Sent from my SM-G955U using Tapatalk Quote Link to comment Share on other sites More sharing options...
Mehridian Sanders Posted December 8, 2019 Author Share Posted December 8, 2019 Please delete this thread it is ill-placedSent from my SM-G955U using Tapatalk 1 Quote Link to comment Share on other sites More sharing options...
Opry99er Posted December 8, 2019 Share Posted December 8, 2019 Just remove all power to the board, batteries, wall power, etc. let it dry naturally. you can put PCBs in the dish washer with the ICs still attached... as long as you don't apply power until it's dry. 1 Quote Link to comment Share on other sites More sharing options...
Mehridian Sanders Posted December 8, 2019 Author Share Posted December 8, 2019 Okee dokee, thank you kindly. I am hoping these can help Falcor4 with his Z80 peb card project should he wish to pick it up again. Quote Link to comment Share on other sites More sharing options...
+OLD CS1 Posted December 9, 2019 Share Posted December 9, 2019 I would also give it a rinse with distilled water. Preferably steam distilled and not purified. I do this plenty with electronics then set it on a cake cooling rack with a fan blowing across it. 1 1 Quote Link to comment Share on other sites More sharing options...
wierd_w Posted December 9, 2019 Share Posted December 9, 2019 Unless there's some particularly soluble parts on the board, a fast spray with 99% isopropyl after the rinse will accelerate the drying as well through dilution/displacement of the water. 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.