widowsson Posted July 30, 2020 Share Posted July 30, 2020 Hi: I need to replace the sound chip in my 99/4A (Unit was working well, now I still have video but no sound at all) I did do what others have suggested and checked the internal 5 pin DIN connections for breaks and all looked well. Besides pulling a replacement chip from a spare board, are there any sources/alternative aftermarket chips that can be used in place of the original? Thanks Quote Link to comment Share on other sites More sharing options...
pixelpedant Posted July 31, 2020 Share Posted July 31, 2020 I was in this situation a while back. Tone Generator 1 had failed on the TMS9919 in my main TI-99/4A (weirdly). I was able to successfully replace it with an SN94624 from this seller. Exactly the same item/auction as listed there, actually. 1 Quote Link to comment Share on other sites More sharing options...
widowsson Posted July 31, 2020 Author Share Posted July 31, 2020 Excellent! Thanks 1 Quote Link to comment Share on other sites More sharing options...
HOME AUTOMATION Posted July 31, 2020 Share Posted July 31, 2020 Some '4a boards use the SN76494, which I believe uses a different timing frequency! A small change in one of the traces on the PCB should allow for this. 1 Quote Link to comment Share on other sites More sharing options...
pixelpedant Posted July 31, 2020 Share Posted July 31, 2020 1 hour ago, HOME AUTOMATION said: Some '4a boards use the SN76494, which I believe uses a different timing frequency! A small change in one of the traces on the PCB should allow for this. My impression had been that the SN76494 used the same frequency divider as the TMS9919/SN94624 and it is the otherwise pervasive SN76489 which differs. Is that not the case? Are there TI-99 units which were originally shipped with SN76489 (or compatible) chips, and wired to accommodate the higher clock input? If I'm reading Thierry Nouspikel's always invaluable tech page on the subject correctly, it seems like both the TMS9919/SN94624 and SN76494 divide by two. 1 Quote Link to comment Share on other sites More sharing options...
HOME AUTOMATION Posted July 31, 2020 Share Posted July 31, 2020 Well, I may not recall the # anymore, but, a couple decades ago... In desperation, I replaced a SN76494, with something I pulled off of a Coleco board. The frequencies were all much lower ...wish I had known then, what I do now. The choice of what CLK to use comes down to W104 vs. W502. I'll see if I can fine a "board pic" of this. 1 Quote Link to comment Share on other sites More sharing options...
AwkwardPotato Posted August 1, 2020 Share Posted August 1, 2020 The SN76494/94624 (haven't come across a TMS9919-labelled chip yet) share the 447kHz clock with the GROMs on most of the TI boards I've seen. The SN76489/76496 take a 3.58MHz clock input, and I've only seen them installed in 99/4 and some very early 4A boards. Correct me if I'm wrong, but I believe you can tell if you need a 3.58MHz-capable chip if your board has the long coaxial bodge wire between the VDP and PSG. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.