Atari 2600 4 switch video mod parts to remove

[runner2019]

Hi, 

 

I've just successfully completed a vintagegamingandmore av video mod on my 4 switch today. The image and sound are ok but there's a little ghosting. Following the web instructions I've only removed the rf box, c209 and q201 transistor. I've seen on different sites though that it's advisable to also remove L201 (the big red piece in the middle) and a couple of other small  resistors. Question is would this really make a difference in image quality? Should I try it? 

 

Thanks

[ApolloBoy]

L201 shouldn't make that much of a difference as it's the coil used for adjusting the audio through RF. The ghosting is inherent to that particular mod I'm afraid, I've tried it several times in different guises and I was never satisfied with it.

[runner2019]

6 minutes ago, ApolloBoy said:

L201 shouldn't make that much of a difference as it's the coil used for adjusting the audio through RF. The ghosting is inherent to that particular mod I'm afraid, I've tried it several times in different guises and I was never satisfied with it.

I see, thanks. Which one would you recommend better than this but at an affordable price also? 

[ApolloBoy]

4 minutes ago, runner2019 said:

I see, thanks. Which one would you recommend better than this but at an affordable price also? 

As far as affordable mods go, the UAV can't be beat. Since you have a 4-swtich you'll need to get the "Basic" kit.

[runner2019]

Just now, ApolloBoy said:

As far as affordable mods go, the UAV can't be beat. Since you have a 4-swtich you'll need to get the "Basic" kit.

Thanks a lot. I'll take a look